Display-devices SE-B6-10 Soffit Series Manual de usuario descargar pdf (Pagina 3)

01-07 3

tel: 303.412.0399 www.displaydevices.com

fax: 303.412.9346 tech@displaydevices.com

5880 Sheridan Blvd., Arvada, Colorado 80003

4.) Raise the unit up on a material lift to the appropriate vertical height. Be sure to have a

sufficient amount of threaded rod to provide leveling room. Add hardware as follows for

leveling: above unit – nut/lock washer/flat washer; underside of unit – washer and nut - do

not tighten yet.

5.) Use a bubble level to level the unit front-to-back and side-to-side. Tighten hardware.

6.) To attach the fire dampers to the intake and exhaust ports use the enclosed Phillips-head

sheet metal screws.

7.) Add runs of ductwork on the intake and exhaust fire dampers. Addition of ducts disperses

the sound further away from the projector. Sound-isolating ductwork is recommended. If

additional sound dampening is desired, we recommend an auto sound insulation material.

8.) Mounting points for a projector mount or lift are pre-installed inside the top of the cavity. The

structural channel can be loosened and adjusted for the proper width of the mount or lift.

Threaded rod

Nut

Flat washer

Split lock washer

Flat washer

Nut

Sound Enclosure

Mounting rails with

pre-installed rods

(under plate)

1 2 3 4 5 6 7 8

Sin comentarios

Display-devices SE-B6-10 Soffit Series Manual de usuario Pagina 3